Caroline Oakes
- Total activity 33
- Last activity
- Member since
- Following 0 users
- Followed by 4 users
- Votes 0
- Subscriptions 23
Articles
Recent activity by Caroline Oakes Sort by recent activity-
Applying feature codes guide
Feature codes are used to enable features on OxTS units, some of which come by default with a unit and others can be purchased for additional functionality. Feature codes are unique to a particular...
Changing the frequency of Freewave Radio
Freewave radio modem Frequency change If 2 base stations are operating in close proximity to each other on the same frequency then it is possible for a mobile unit to receive differential correctio...
Radio Communication; Satel radio firmware roll back guide
Satel Radio Firmware Roll Back Guide. The 869.4125MHz radio firmware has been updated by Satel to SATELLINE_EASy_869_fw_06_26_3_63_8 This firmware puts a limitation on the output of the radio crea...
Static Roll Test
To use the RT for a static roll test, please follow the procedure below: Initialise the system and do a full warm-up procedure. Over a period of about 20 minutes of being stationary the accuracy w...
Internal vs External GNSS
What is the purpose of the internal receivers on an Inertial+? Imagine you're using an Inertial+ with an external receiver and the internal primary receiver (secondary antenna not connected). The e...
Calibration Options
Will the accuracy of a sensor be degraded if it is out of calibration? The calibration only effects the IMU so the main effect of being out of calibration is that when the system depends more in IM...
GNSS time to output
Why does my system take such a long time to get a position solution? The system may be having to undergo a "COLD_START" which refers to the system needing to download the GPS Almanac ( which consis...
Differences between GNSS constellations
What does GLONASS functionality add? The addition of GLONASS functionality doesn’t necessarily improve the position/orientation accuracy of an INS , but it does increase the number of satellites av...
Considerations when mounting the RT Split
Considerations when mounting the RT split When setting up the RT-Split there are couple of considerations that you should make sure to take: The wheel mounting solutions that OxTS have at the mome...
Optimising the output of the RT
1. Introduction: The way that out units calculate and output slip angle has the following major dependencies: Good heading accuracy Antenna separation (Dual antenna systems) Speed of vehicle ...