Avatar

Caroline Oakes

  • Total activity 35
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 20

Activity overview

Latest activity by Caroline Oakes
  • Avatar

    Caroline Oakes created an article,

    Changing the frequency of Freewave Radio

    Freewave radio modem Frequency change If 2 base stations are operating in close proximity to each other on the same frequency then it is possible for a mobile unit to receive differential correctio...

  • Avatar

    Caroline Oakes created an article,

    Radio Communication; Satel radio firmware roll back guide

     Satel Radio Firmware Roll Back Guide. The 869.4125MHz radio firmware has been updated by Satel to SATELLINE_EASy_869_fw_06_26_3_63_8 This firmware puts a limitation on the output of the radio crea...

  • Avatar

    Caroline Oakes created an article,

    Post Processing guide

      1. Introduction This guide will outline the general work flow of post processing your data using OxTS's processing engine wizard, RT Post Process. Topics covered in this guide will include:  Arr...

  • Avatar

    Caroline Oakes created an article,

    Applying GNSS Auth codes

      Process to apply a GLONASS Auth code to an RT or xNAV Ensure that the computer is correctly configured to communicate with the RT. To do this the first part of the computers IP address must matc...

  • Avatar

    Caroline Oakes created an article,

    Static Roll Test

    To use the RT for a static roll test, please follow the procedure below: Initialise the system and do a full warm-up procedure. Over a period of about 20 minutes of being stationary the accuracy w...

  • Avatar

    Caroline Oakes created an article,

    Displaced Output

    How to measure accelerations at the vehicles centre of gravity There are two ways to do this Mount the RT at the Vehicles CoG, or Displace the output of the RT to the vehicles CoG Displacing the ...

  • Avatar

    Caroline Oakes created an article,

    Internal vs External GNSS

    What is the purpose of the internal receivers on an Inertial+? Imagine you're using an Inertial+ with an external receiver and the internal primary receiver (secondary antenna not connected). The e...

  • Avatar

    Caroline Oakes created an article,

    CAN acquisition

    Is my RT capable of acquiring CAN messages? The CAN acquisition upgrade option can be purchased from OxTS if the following conditions are met The unit has a TP500 or TP600 processor The unit has t...

  • Avatar

    Caroline Oakes created an article,

    Calibration Options

    Will the accuracy of a sensor be degraded if it is out of calibration? The calibration only effects the IMU so the main effect of being out of calibration is that when the system depends more in IM...

  • Avatar

    Caroline Oakes created an article,

    Garage mode

    What is Garage mode? With the garage option enabled, GPS will be blocked when the vehicle returns to the garage.  You increase the initial delay if the vehicle is to be used in tunnels or where GPS...