This article aims to detail the steps required to change and save default GPS-Base Settings
If there will be day to day data comparisons, you may want to assure that your positional information remains constant. The reference location of the GPS-Base is not saved by default and if not saved, the reference location will be shifted upon a new position averaging or power cycle. This will result in a change in reference location relative to reference locations established using previous position averaging. This article will aid in creating repeatable position data.
Steps to set default Corrections Type and Save Position to GPS-Base
Launch NAVsuite and click on NAVbase
- Product Selection
- Select "GPS-Base" -> Next
- Connection
- The allocated COM Port will be scanned and selected for that session -> Next
- Settings
- Select "Averaging time" and the desired "Averaging time" from pull-down
- Click on "Advanced" Select desired "Correction type" from pull-down -> Ok -> Next
- Status
- While the Status is "Averaging" Select "Select file" in relation to Save Settings to GPS-Base
- This step saves the current configuration to the GPS-Base (including the desired corrections format)
- While the Status is "Averaging" Select "Select file" in relation to Save Settings to GPS-Base
- Status
- Once Averaging is complete and Status is "(desired corrections format) OK" Select "Select file" in relation to Save Position to GPS-Base
- This step saves the antenna position and might be used if the antenna position is permanent
- Once Averaging is complete and Status is "(desired corrections format) OK" Select "Select file" in relation to Save Position to GPS-Base

- Status
- Select “Finish” -> Select “Yes”

Comments
0 comments
Please sign in to leave a comment.