RT-Maps is a useful piece of software made by Intempora which allows the user to link various sensors and other hardware equipment to create complex frameworks in an easy to use block diagram system.
This guide will provide you with resources to help jump-start your development but for more in-depth information contact RT-Maps
Once you have downloaded and registered for RT-Maps from this link follow the rest of this guide to get up and running with your RT and RT-Maps.
After plugging in your RT open the file attached to this article titled test_oxts_recording.rtd.
This file will allow you to see the output of various measurements from the unit and record the NCOM stream to a file location of your choice.
Before running the program check that the UDPsocket is configured for your unit.
-Select the UDPSocket Block
-Fill in the Remote Port and IP address for your unit.
If you would like to record the data in RT-Maps format then you will also need to configure the RecFile block in a similar manner.
Run the program by selecting the power icon in the toolbar.